ʻO Polyethylene Pipe pono PE peʻe kuʻekuʻe 45 ° No ka wai anuanu a me nā kahe

● Material: 100% new raw material.

● Working pressure: SDR17, SDR13.6, SDR11,PN10, PN12.5, PN16.

● Size: dn63mm to dn800mm.

● Color: Black or customized.

● Usage: Water supply,sewage transfer, covering cable and so on.

● Service Life: More than 50 years under normal environment.

● Laʻana manuahi
● Custom made as your request
● Quality guarantee
● OEM is ok

Pūnaehana Waiwai

● Transportation and distribution system.

● House service connection.

● Agricultural irrigation.

● Non-toxic: HDPE pipe material is nontoxic and tasteless pipe which belongs to green building materials. No heavy metal additives would not be covered with dirt or contaminated by bacterium.

● Lower Installation Costs:light weight and ease of installation can reduce installation costs by as much as 33% over metal piping system.

ʻO ke kaupae hoʻonohonoho

● In the butt fusion of HDPE pipes, a special fusion device is used, butt fusion welding machine.

● Clean the ends of pipe and fitting, to make sure pipe and fitting are completely clean and free of waste.

● Fix the pipe and fitting in the welding machine, cut the both end of the pipe and fitting, to make sure two ends of pipe and fitting are completely flat and free of defects. Please pay attention on no gap between two ends.
● After finishing above steps, the operator put the heating plate between the two simple pipes’ (or fitting’)ends and bring the pipes ends to the metal plate gradually, so that the ends melt. Most important, before connect the power, please make sure the heating plate is completely clean.

● After end of pipes or fittings melt enough, it’s necessary to remove the heating plate from the pipes or fittings, and within 10 seconds to connect two end slowly and carefully, don’t move until the solid connection build.